隨手記錄

BURST_PATTERN

L5710 Tester - 指令 - BURST_PATTERN

The BURST_PATTEN instruction is used to test the result of a functional pattern execution, resulting in a pass/fail decision.

*Syntax:

BURST_PATTERN( Pattern_Name, Start_Address, End_Address)

*Arguments :

Pattern Name： any pattern name which had been defined by the user in the test program.

Start_Address： the address which begins to burst.

End_Address： the address which stops burst.

*Comment:

The BURST_PATTERN instruction provides the information required to start a functional test. After starting the pattern, the system waits for completion of the test, by a pass, a fail, an interrupt from the high-speed pattern controller. upon receipt of one of these conditions, the pass/fail decision is performed.

Burst pattern from start_address to end_address, which is given by the user. The Start_Address, End_Address can be used by level or UMA address.

*Example :

DPS FV(DPS1, 2.400V, V2I6);

SET_REF_LEVEL(LOW_VOLTAGE);

WAIT(5.00ms);

BURST_PATTERN(FUN, L1, L2);

→L1, L2 is the label name

SET_REF_LEVEL(INIT);

DPS_FV(DPS1, 0.000mV, V2I6);

...

...

BURST_PATTERN(FUN, 100, 500);

→100, 500 is the UMA address

#關鍵字 L5710 Tester - 指令 - BURST_PATTERN

■ 延伸閱讀 ：L5710 指令說明 & 其它